- Heat pump should be installed in a place where free air circulation is available. Heat pump generates heat from atmospheric air.
- Ensure 1000mm of clearance all-around of the heat pump to allow air circulation and access for maintenance.
- Do not block the top air exit for top mounted fan models. Shade shall be provided 2000mm above from top of heat pump.
- Avoid positioning heat pump in such a way that the control panel does not face directly Sunrays.
- Heat pump must be placed in proper levelled civil floor. even if it is installed in landscaping area proper pedestal to heat pump to be made & installed.
- Distance between heat pump and pool should be as short as possible to reduce heat loss and pressure loss in the pipe work.
- Isolator switch should be installed (by a qualified electrician) near the heat pump.
- Electrical supply to the heat pump must be protected by an MCB & ELCB.
- Air inlets and outlets must not be obstructed or blocked by any means including shrubs & bushes.
- Our heat pumps are additionally protected with VMR to avoid & protect electrical fluctuation in incoming.
- Heat pump must be installed in downstream, after pool filter so filtered water passes through it.
- Each model heat pump performs with minimum- maximum water flow rate. If the flow is higher than required, need to be bypassed. If the flow is lower than required, system would not work & you need to check pump flow.
- Correct sizing Pipework to be installed between pool & heat pump to ensure correct flow & pressure is achieved at heat pump.
Best installation practices been given below.
